Doctoral candidate Tove Ilesanmi, with Halvard Nnamani and Associate Professor Ragnhild Uzoma, shows that the heating ramp used to prepare a dry reforming catalyst sets most of the carbon it carries a hundred hours later.
How fast a nickel-cobalt reforming catalyst is heated before use decides how much carbon stays on it for the next hundred hours
The School of Emergent Priorities has made a habit of asking what is settled before anything officially begins. Its newest paper takes that question to a laboratory furnace.
In Carbon Laid Down in the First Hour, doctoral candidates Tove Ilesanmi and Halvard Nnamani, with Associate Professor Ragnhild Uzoma of the School of Underlying Conditions, prepared one nickel-cobalt catalyst four ways and followed it through a hundred hours of turning methane and carbon dioxide into synthesis gas. The faster the catalyst was heated during its preparation, the more carbon it gathered in its first hour on stream, and that early carbon was still there, in much the same proportion, at the end.
I had always thought of start-up as the part you get through before the experiment. On this catalyst it is part of the experiment, and I have found that a very good thing to learn.
— Tove Ilesanmi, Doctoral Candidate, School of Emergent Priorities
The study positions activation protocol as a first-order variable across the catalyst lifecycle, bringing reactor practice, bench-level carbon accounting and long-duration stability testing into a single conversation about readiness.
Associate Professor Uzoma described the collaboration as work in which “the bench and the corridor turned out to share a fire door, and we have been glad of it.”
The University welcomes the paper as further evidence that some of its most consequential work takes place in the hours nobody thought to schedule.
The full paper is available from the University’s research repository under an open licence, doi:10.5555/slop.4mpuoz.