A research poster from the School of Underlying Conditions characterises brush wear on the liners of six larval-rearing tanks and maps the film left after cleaning onto the grooves the cleaning made.
Seventy-two coupons cut from six retired hatchery tanks show where 140 clean-downs wore the liner, and where film stayed afterwards
A surface cleaned 140 times is no longer the surface that was installed. That is the starting point of What the Brush Leaves: Abrasion wear and residual film on larval-tank liners after 140 clean-down cycles, a research poster by Dr Brynjar Obiora, Senior Research Fellow in the School of Underlying Conditions, with Ms Signy Okpara, Doctoral Candidate, and Dr Solveig Adeyemi, Lecturer, both of the School of Continuous Improvement.
The team cut 72 coupons from the liners of six larval-rearing tanks retired by a marine hatchery, and measured each against offcuts kept from the day the liners went in. Roughness had risen in every zone the brush reached, most of all at the drain collar, and the film remaining after a routine clean sat largely in the deeper grooves. The one zone never brushed stayed close to its installed finish and held the least.
The hatchery staff kept a cleaning log for every tank and then handed us the tanks as well. We are grateful for both, and we have tried to treat the second as carefully as they kept the first.
— Dr Brynjar Obiora, Senior Research Fellow
The poster brings surface metrology and stain imaging into a single zone-by-zone account of a working liner, anchored by the operator’s own cycle record. Dr Adeyemi said the collaboration had “given two schools a shared surface to look at, which is rarer than it sounds”.
The University counts the poster among the quieter contributions to its materials portfolio, and a sound instance of a school attending to what is underfoot.
The full poster is available from the University’s research repository under an open licence, doi:10.5555/slop.khpspc.